Have these items available:

Mark I switch tamper with shoulder jacks and light buggy
1992 Mark III tamper; 4WD; combo clamp; graph table; Lt buggies, exc. Condition
Mark III tamper, completely updated by Norfolk Southern Corp.: Jupiter operating system, hydraulic tamping heads, 4WD, combo clamp, folding light buggies
2005 Ford L9000 Box truck with NLB Corp. 40K water blaster; 491 diesel V8
1999 Jackson 2400 tamper w/ light buggies; Cummins engine
5TM Trackmobile; Fully rebuilt
1991
TKO Tie Inserter
1997 TR-10 tie inserter/remover; work-ready
TR-1 tie inserter/remover with TR-10 upgrades; job-ready
2005 MBTX tie exchanger
1977 Michigan 175B Rubber-tired loader, complete with forks an bucket.
2005 Ford 350 Extended Cab; hydraulic hi-rails; hydraulic tool outlets; utility bed; reasonable miles
2003 Chevrolet 2500 4-door pickup truck. 8 cylinder gas engine; 151,000 miles; Hydraulic hi-rails; utility bed; New paint
1995 Ford L8000 hi-rail rotary dump with Hawk 1200 loader (clamshell attachment)
1989 Chevrolet Top Kick rotary dump with DMF hi-rails; only 57,000 miles on truck
1987 GMC brigadier rotary dump with DMF hi-rails; CAT diesel engine; 12' bed
RTW Tie Handler; Detroit diesel; joy stick controls; complete and in good operating condition
2006 Sterling grapple truck; Only 128,000 miles. CAT C7 engine; mag/gen set; comes with air brake equipped rail trailer
2005 Sterling hi-rail grapple truck; Mercedes OM460 engine; Serco Model 8500 crane
1999 International Flatbed Grapple truck; DMF hi-rails; Hawk H-1200 Knuckleboom Loader
1993 White GMC hi-rail grapple truck; 20' steel bed; 8,000# capacity loader; DMF hi-rails; mag/gen set
2000 Little Giant 25-ton crane with hi-rails
1980's Model 40 Burro crane
2005 Chevrolet 7500 service truck; Duramax diesel engine; Single-axle; Autocrane and air compressor
1977 BEB17 Ballast Regulator w/ hydraulic wings; New pumps and brooms; overhauled transm., gear boxes, and rear ends
1990 Canron CSC2 Ballast Consolidator; Serial # A481747
1980's Kershaw 26-2-1 ballast regulator; with turntable
Kershaw 26-3 ballast regulator; rear-door entry
2000 Little Ben Brush Cutter; hi-rails; CAT 3306 engine; 4WD
2010 Nordco Grabber; two-sided spike puller
Fairmont W96 Dual Spiker with nipper and updated spike feeders and gaugers
4 Ea. Hand tamping tools ("Jitterbugs") with generator
Stanley hydraulic power pack; two-tool
Rail grinder w/ 8HP gas engine and flexible hose


If interested in item, can email photos.

Contact:
U.S. Rail, Inc. | P. O. Box 25392 | Greenville, SC 29616 USA | 864-832-7245 | FAX: 864-627-8713
Email: info@usrailinc.com